EAS-HEVAssembly Sequence
 

Plug-In Hybrid Assembly Sequence

Each step of the conversion of hybrid drive to plug-in capacity is illustrated in comprehensive detail.  The course uses over 50 video segments to enhance specific details of the conversion steps in minute detail.

right arrow Step 1: Rear floor removal
right arrow Step 2: Remove OEM battery cover
right arrow Step 3: Remove service plug
right arrow Step 4: Remove side panel (driver)
right arrow Step 5: Remove side panel (passenger)
right arrow Step 6: Disconnect accessory battery
right arrow Step 7: Remove rear upper vent
right arrow Step 8: Remove rear seat
right arrow Step 9: Remove rear lower vent
right arrow Step 10: Fan cut-in
right arrow Step 11: Remove high-voltage cover
right arrow Step 12: High-voltage tie-in
right arrow Step 13: Remove brake control power assembly mount
right arrow Step 14: Remove underside guard
right arrow Step 15: Remove/replace rear springs
right arrow Step 16: Install battery box
right arrow Step 17: Install charge plug
right arrow Step 18: Install diode wiring
right arrow Step 19: Install batteries
right arrow Step 20: Remove door lining
right arrow Step 21: Remove dashboard
right arrow Step 22: Harvest Toyota pins
right arrow Step 23: Install ICE emergency cutoff switch
right arrow Step 24: Install EV wiring circuit
right arrow Step 25: Install rocker switch
right arrow Step 26: Install ethernet cable
right arrow Step 27: Install control box

 

back to Courses

Post Your Own Content!
School project pics & stories

Have a helpful technical fix? Share your EV expertise!

Funding assistance is available - Qualify now!

Read about our latest school successes here.